Last seen: May 14, 2023 7:10 pm
Good info, thanks for the feedback. I've tried to pull the air release slowly but takes too much finesse and not always guaranteed. I'm running an ...
Update. I got a hold of Lister direct. They said 'The seal you are missing was discontinued at least 5 years ago, it was added as a precautionary meas...
I called the guys at XRP this afternoon. They mentioned early generation air jacks only had one seal, but based on my photos and yours Charley this is...
@thunder1375 Are the upper and lower seals supposed to be the same size? mine are and doesn't seem they should be. I did manage to put th...
Took it back apart. Where is this 2nd seal supposed to go? The AL portion is narrower and had a much larger OD.
Hang on a minute, is there supposed to be two seals here? That must be it. How does the other one orient?
Seals are installed the say way it was before (don't have a baseline reference). It behaved this way before seal installation and after. Can you confi...
Rod, 1. When the car drops after putting my weight on it, it stays in that position after I let go. 2. The other corners don't behave the same...
I have the 3.5 V6.
@clark-darrah Thanks Clark. This is all good info. I did find my rear air-jack to be off vertical and a bit of an angle. Strange I say. I need to look...
Perfect, thank you for the pictures. Looks very straight forward. Like you said the hard part is getting it out! Googling that part #, I see it ...
@charleyhradicalsportscarregistry-com Awesome, thanks Charley! I found the manual for the AP Racing unit, and the list of special tooling was incredi...