Last seen: April 14, 2024 6:21 pm
@davidf - Thanks David - that will be a very good head start once I get my car back together. My only concern with what you have shown is that the t...
Some good suggestions by bothers including the penetrating oil and Milwaukee 18v impact wrench you have.... ultimately the answer may well be as simpl...
Hi David, ... so to be clear these strips (in that temperature range) are the ones you suggest using on the uprights bearing carrier? I already use t...
Hi All, I thought I would post my suspension bush question here as it’s at least related to this topic. I’ve suffered some damage from a crash abo...
@helmutweber ... there's not much 'e' about that box... mostly pneumatics in there. The 'e' part of this box contains the 3 solenoids that drive the ...
@davidf ... Great insight David. I don't know much about the TPS either.. but I do know where to buy them as I purchased a spare based on some previo...
@davidf - Thanks David, Appreciate you sharing your replies. Just checking that when you say you run “hole 3 from the bottom” on the main plane that...
Hi All, I basically have the same question that @trakmnky started this thread with, and I appreciate CharleyH's input above. I was wondering if a...
@schneller - G'day Ron, You can see the end of the shaft up the middle of the hub. I think another way around that issue would have been to use a br...
@bird - Hi Jay, Main dimensions are 40mm wide and 215mm long. The material I used is 2.5mm thick (anything between 1.5 and 3mm would work really, as...
@bird - Hi Jay, Yes. That's another thing I made and helps enormously when you are trying to maximise the use of the RPM shift lights in bright sunl...
@bird ... Hi Jay, Yes, that's something I made very early after buying my Radical and getting it up on my jack stands for the first time. I wanted a ...
@bird - Hi Jay, Radical wanted around AU$700 per set.... So we made our own from some 5/8" diameter (or 16mm) 316L stainless steel bar, and purchased...