Andy
Andy
@captainslow
Active Member
Joined: February 9, 2020 10:45 am
Last seen: October 30, 2021 10:12 am
Topics: 3 / Replies: 7
Reply
RE: Engine hours until refresh

One would have to assume that 40 hours is a conservative estimate on Radicals' part such that they can offer a warranty. They will also keep a databa...

4 years ago
Reply
RE: RPE factory sealed SR8 engine For Sale

Charley, out of curiosity, so I can check mine, what is a crank pulley pin? Here's a couple of pictures, one of each end of an SR8 crank, and I don't...

4 years ago
Reply
RE: SR8 fuel pressure

Mine used to have the cheap and cheerful $25 Bosch fuel pressure regulator in it that is a 3 bar regulator so one would assume 3 bar. I replaced it w...

4 years ago
Reply
RE: SR8 Clutch Slave Cylinder

I'm guessing you have the round (O ring) style seals in the slave cylinder. Radical do make square section seals, which are better, but have not comp...

4 years ago
Reply
RE: SR8 Final Drive and Gearbox Ratio's

John, following our call the parts are different. I think the later box is the E-72G. -Andy

4 years ago
Topic
Topic
Replies: 2
Views: 533
Topic
Replies: 6
Views: 1194
Reply
RE: Brake conversion Carbon to steel - need to source calipers and rotors

I haven't read everything mentioned above so apologies if this is repeated information. SR8 300mm rotors do fit inside the standard 15" wheel. I usu...

4 years ago
Reply
RE: SR8 alternators and starters

Summit Racing has them new in a box for $106.99 (Denso Remanufactured Alternators 210-0338) Having said that my car still goes through alternators l...

4 years ago