99sh

It's a larger car and generally more expensive for consumables. Tires, fuel, oil and parts will run you more. I recently had to replace my fuel bladder, these run about $9000. So cost that in your 5-7...

Has anyone replaced the belt for the dry sump? There's little to no space to do anything here. How do you remove and install the cogged belt? Attachment : IMG_0301.jpeg Attachment : IMG_030...

I finally removed my fuel bladder. It's not hard after you figure out the steps to get there. The one difficult part however was removing the bladder and accommodating the two rear ports for the fue...

Thanks for your input. Interesting they have an AL option, I'm not sure what to think of that. Curious - does the lower skirt come off on its own, or did you have to remove other hardware to get to ...

I'm encroaching on 7-yrs for my ATL fuel cell which has been recertified once. I'm planning to replace this winter and pre-planning. Has anyone removed one before? Looking for any guidance, awareness,...

Good info, thanks for the feedback. I've tried to pull the air release slowly but takes too much finesse and not always guaranteed. I'm running an AP Racing air jack connector. Let me try a manual ba...

Does anyone have any recommendations on how to slow down the decent of the car dropping when pulling on the air jack valve?

Update. I got a hold of Lister direct. They said 'The seal you are missing was discontinued at least 5 years ago, it was added as a precautionary measure for around 12 months but was proven to be unne...

I called the guys at XRP this afternoon. They mentioned early generation air jacks only had one seal, but based on my photos and yours Charley this isn't the case here. He also initially stated that h...

@thunder1375 Are the upper and lower seals supposed to be the same size? mine are and doesn't seem they should be. I did manage to put the seal in the lower groove (after a lot of effort) but sin...

Attachment : PXL_20221211_230952470.jpg Took it back apart. Where is this 2nd seal supposed to go? The AL portion is narrower and had a much larger OD.

Hang on a minute, is there supposed to be two seals here? That must be it. How does the other one orient? Attachment : PXL_20221209_214604183.jpg

Seals are installed the say way it was before (don't have a baseline reference). It behaved this way before seal installation and after. Can you confirm? Cylinders are closed up but I can try. I did '...

Rod, 1. When the car drops after putting my weight on it, it stays in that position after I let go. 2. The other corners don't behave the same way when I weigh it down, it's rock solid 3. I'm runnin...

Have an ajr jack issue hoping you guys can help. The front right air jack is last to pop up and first to retract on my car. When the car is jacked up, the front right will retract if I put my weight o...