Rod Bender

@ak47si ... Hi Alan, That looks normal (and the stickers are normal too - I'm not sure buy I think they used to offer an option of proper lights...) I suspect you will need to log into the AiM or Lif...

Hi Alan, I'm not sure what your fault is, but DRL is the term used in the PDU/PDM (SR3XX's were supplied with both AiM and Life units depending on chassis number) for 'Driving Lights', so I suspect ...

@ rojid ... For reference, see below a set-up sheet for my RSX - while I adjust a few things for different tracks (rear wing, front dive planes on/off, final drive gear ratio, etc) this sheet is a go...

@rojid As you have said... you should have been given a 'set-up sheet' after your car was adjusted on the flat patch. I would ask whoever did it as I'm almost 100% sure they will keep records. Not k...

@ meatman The Forum Search Tool is your friend... .. you are probably using the Motul 75W-140... others use the Neo-Synth 75-90... their are people that have used both and have developed a preference...

@jeff-alton ... Hi again Jeff, Dan Phillips at RLM is the likely person who might know.. but as I understand it, the new oil specification is focused on the new "-X" changes to the journal/bearing arr...

G'day @rojid I'm no fibreglass/composite expert so I'll leave it to others to comment on your repair plans. There does seem to be a fair bit of work involved.. have you considered buying a new split...

@jeff-alton ... agreed - it would be great to hear what the exact issue is they are trying to solve with this change in viscosity 'requirement'... I understand a little about lubrication, etc and I c...

@ezabala8 … I haven’t replaced any, but have removed a couple… from memory it was as simple as it looks. Once you’ve got the arm off the car and the upright, then remove the circlip and press the sphe...

G’day All, Thought I’d share this idea for those with OCD tendencies like me… I’m tidying up my brand new SR3 XX and was getting sick of getting copper anti-seize on me when working around each corner...

@charleyhradicalsportscarregistry-com Thanks Charley - I'm actually really only taking the opportunity to do some 'preventative maintenance' while I'm preparing to rebuild my car after a pretty big sh...

Hi All, I'm hoping someone can help with some advice or photos of their water pre-heater connections. I'm building a water pre-heater that will run on 240v supply and will include an off the shelf 2...

Hi @jeff-alton I experienced the same 'sensation' the very first time I drove my RSX, after racing karts and heavily modified road cars for 30 years... and I have others say exactly the same thing as...

@jeff-alton ... G'day Jeff. Just to be clear... keeping the revs down would have the opposite effect of 'helping'.... keeping the rpm lower will have the effect of limiting the heat generated in the ...

Ok.. its' me here again!... I took the Dremel to the gear change actuator and managed to make that work so I could get the wire retaining clip out... Then I've struck another issue... I can't get the...