Strange one that Gordon, the engine mount points are the same for all the Busa engines so it should fit straight in. As you removed an engine that w...

Firouz, When you power the car on does the AIM show things like the water and oil temperature? Can you plug in your laptop and connect to PT Mon ...

@meatman Its hidden in there. Located between the cast pot and that black plastic top so just bolt it on (either with a new gasket or gasket sealant...

No problems! This is an example of a Gen 2 breather pot so you know what you are looking for:  

Morning Rene, Good to see you on here! Hope you don't mind me popping up in this thread, I am also open to hearing everyone's experience and thoug...

Morning Josh, Apologies if I am repeating things you already know or have been mentioned but my best guess is that this is an earlier car that once ...

Hi Josh, apologies for the delay. I would tend to agree that it looks like a thrust mark, especially being on the exhaust side and not between cylin...

Hi Josh, Are those markings on the wall between the bores or at the front/rear of the cylinder? In the first picture I wouldn't be too concern, al...

Hi Josh, Sounds like you are there with the plumbing, although that oil level sounds low to me? Is there a later tank that you could fit that is lar...

Has this a problem that has just started or been there as long as you have owned the car? AN12 or even AN16 feed on later cars with an AN10 return i...

The only way to test them would be to build yourself a flow rig. They rarely go wrong to the point they would cause issues like that, it would have ...

A flat ECU battery will not cause the issues that you are suffering, this is only for data logging and engine hours. Sounds like the dash is loosing...

The owners manual recommends 98RON UK spec, Oxygen 2.9%, less than 5% ethanol - Like Shell V Power over here. It also mentions you can use Sunoco 2...

Hi Cheddar, Attached is the section from the owners manual on the pin out for the radio plug. Hope that helps!

Hi Jeff, There should be a fuel pump relay somewhere. I think on those cars it was located on the bulk head near the ECU? I would be checking that...