Last seen: February 2, 2024 2:51 pm
Sent you a PM
Confirmed the bearing did fail. Tons of loose metal inside. I’ll be ordering a new engine as the lead time is 5-6 weeks vs rebuild which is 3-4 mont...
@raider89, Spring Mtn also makes a screen that you attach to the underside of the louvers. I can't recall the cost, but they are not expensive.
Yes, the wheel wells develop high pressure and the vents are there to relieve it to better allow the underbody to do it's work generating downforce. ...
The car is at the shop so I can't get a measurement today. The engine is coming out and we are going to open the case to see how much damage there is...
Dan, thanks for the input. Wow much worse than I expected. I attached pics of the rod. Engine is a 1340cc. 50 hrs total, 30 on load hrs. Was new ...
That's great! My 2 day fedex appears to have gotten lost in Memphis so I ordered another set today.
These mid cycle improvements are more significant than the RSX to XX changes.
@davidf From the picture these look more like the ones that came off the car. The ID measurements are much closer too. I will order some and give...
I am having trouble matching the correct size. Looks exactly like the washer on the right in Dan's picture above. The outer diameter matches a 1/2 B...
That stock muffler is tiny. Must be the “loud” muffler option?
That's strange. My brake bleeders are 11mm. Nice tip on the clutch bleeder wrench.
Thanks for the inputs, @davidf and @gwt561324. Looks like I should be ok for our sprint races without any ballast, especially since we start each rac...
Wow, I'm surprised. I heard others in our club complained that they were at a disadvantage to the smaller guys, but in this case nothing would change...
I'm not sure this is always the case. My Porsche made the journey from Germany to San Diego pretty much as scheduled, leaving in July and arriving in...