Notifications
Clear all
Early Gen1 SR3, 1300 oil psi sender location?
Topic starter
May 27, 2020 11:34 pm
i have an early gen 1 car that I'm finally about to finish up a complete bare frame rebuild on. It came to me partially dissembled so I'm unsure of where the oil PSI sensor should be installed. There was a PSI sensor connected to the loom that dangling from wires but wasn't installed in anything. There also doens't seem to be an obvious bungs (that are currently plugged) where it would get installed. Anyone have photos of their engine that show sender locations?
thanks!
Quote
Forum Information
Our newest member: Dan Redpath
Latest Post: Clubsport/Prosport brake caliper questions
Forum Icons:
Forum contains no unread posts
Forum contains unread posts
Topic Icons:
Not Replied
Replied
Active
Hot
Sticky
Unapproved
Solved
Private
Closed