It should allow you to connect and download the chipfile, once downloaded you should be able to email it like any other file.
Have similar problems with starting from cold or lunk warm. Use parallel starter battery. Turns over good, but must be cranked for a long time before firing (after a few chokes). Once warm starts easily on onboard battery. 12 volt starter. SBD ECU MBE9A4. Any suggestions?
Hello I have same problem.
Cold start is a nightmare...I I'm.now with 24v dual batteries system. The ignition coil (Valeo) is new, the ignition wires to the spark plugs are new,the spark plugs are new to ( they are not iridium they are simple NGK).
My 2 batteries are charged. When I try to start , the car make some explosions and the spark plugs are very wett like if it was too rich mixture. I remove the spark plugs and heat them. I installed them again and the engine start..it's smoking black grey for one minute and after that it's ok and the restarting is fast.
I don't understand what is wrong.
I manage to start it quickly when I put new spark plugs. But only one or 2 starts.
Too ihave a harness magnecor wires set and I feel that it is worth with it 'some mor ohme resistance on each wire)
I was thinking about changing myCR9 spark plugs with iridium ones ? can be better for cold start ?
Thanks for helping me.
Nico
