Andrew A

Hi all - what cylinder pressures are you typically measuring for a 1500? I’m running a K7 motor, not sure how different pressures are from the K8?

Thanks Charley - this will be useful for me as I’m having a water temp display issue on the dash (sender is working because I can see it when I plug into the ECU). side question, what are the options...

This is a long shot, but does anyone have any spare sockets for the Sure Seal receptacle? I was going to assemble my own connection to the pump out, but this part is missing world wide (at least at t...

@charleyhradicalsportscarregistry-com @ntf3000 Thanks for the comments. Looks like I'll be pulling the motor in the coming weeks. @Charley - you had mentioned that you send out your oil for inspecti...

Thanks @rlm-dan and @charleyhradicalsportscarregistry-com Noted on tracking hours properly. Sorry I was not clear before - the picture of the shiny metallic particles in the oil is actually of the b...

@charleyhradicalsportscarregistry-com Thanks Charley - It's true the hours are hard to track. I've created my own spreadsheet to log the on-track hours but I still have to rely on previous owner inf...

Hi All Looking for help with inspecting the oil from the filter. Attached are a few pics. The filter element had a few small metallic pieces in it. I’m assuming steel from gearbox. There seems to be...

@rlm-dan I’m not sure what engine temp is as the sensor is not sending to the dash properly. Oil temp is at the min reading of about 45C. But since the fan seems to be turning on then maybe the senso...

@rlm-dan attached is a pic. Do I need one of it removed? I think the issue is definitely this sensor because the blue housing can spin around freely. Will this also affect when the radiator fan tur...

I have an additional question. Is the temperature sensor on the left side of the block an OEM hayabusa sensor? Or is it something different? Thinking about replacing as the reading on the dash is not ...

Thanks @rlm-dan! My dash is reading temp from the other sensor on the side of the block, so I think the entire standoff can be removed. Feels good to add lightness.

Hi All I sprung a leak out of the potting of this electrical component connected to the thermostat housing. I guess it’s not the thermostat housing but a stand-off for the thermostat housing. What is ...

Hi Dan, The old rotors I pulled off are the same diameter as the new ones I purchased (from Spring Mountain). I assume they are OE but not entirely sure. OD of the rotor measures 10.25” The old rotors...

Hi All, I was replacing front rotors and pads and noticed wear on the caliper cross bar where the tops of the pads touch. Should this cross bar be replaced? One pic is of the left (more wear) and the ...

FWIW I just took apart my master cylinders due to leaking on front and clutch. Here were my sizes: front: 0.70” rear: 0.75” clutch: 0.625” There was pretty bad scoring on the front and clutch, so I’...