CharleyH .

HI @ezabala8, Since you have a Gen 1 SR3 it could either be in the side pod or in the engine bay. is your car fuel injected or carbureted? I would recommend following the fuel line from the engine a...

Hi Erik (@ezabala8), The ECU's have moved around a little bit, but the MBE ECU's are typically mounted in the front of the engine compartment on the right hand side. They are mounted on the firewall ...

Hi Erik (@ezabala8) What chassis number are you restoring? Unfortunately the gen 1 cars with the MBE ECU don't have data logging capabilities like the 2009 and later cars with the Live Racing ECU's h...

Hi Erik (@ezabala8), Here are a few graphics that show the parts of the system. Basically there is a pivot bar between the front and rear master cylinders and depending on how you adjust the cable co...

Hi Rod @rjbender you likely already know this but that gold anodized end of the actuator can be replaced (including the bearing) without replacing the entire actuator. I would think your local dealer...

Here is another view of the measurements for the Race Ramps. Attachment : IMG_0201.png

@jeff-alton, have fun and work your way up to speed slowly. Just to warn you there is a common “heart attack moment” that almost every new SR3 owner has. Once you are out on the track for a while an...

Hi @jeff-alton, it is great to hear that you got it out on the track, congratulations! Yes, it is amazing what a step up these cars are over production based cars. 🙂 What you are experiencing...

@vhtracing, I am traveling for a few more days, but I will post some pictures as soon as I get back.

Hi @vhtracing, y understanding is that these parts are made specifically for Radical and Radical only sells them to Radical certified engine shops. I don’t think it is the same piston that is used ...

Hi David (@davudf), this is a very nice offer, but I would recommend reaching out to Roger Burgess at Radical Canada East because he is often looking for good core engines to buy.

@fsts2k, looks like a great solution!

Hi @bensworth1, Unfortunately I don't know of any that are currently available.

Hi @michal, welcome to the Registry! I have never seen a set like this before, but, as you mentioned I was able to look through some of the early cars in the Registry and I found a similar set on Club...

@nickallitt, 260 ft lbs is correct. The recommended torque value for the wheels changed over time because the Radical team is continuing to learn as the cars are in service. The value crept up over ...