David Flynt

Posted by: @drugg1st How are the black buttons compared to the colored ones, any real differences in tactility etc? I think not a significant difference, but now that you ask I will pay attention ne...

Posted by: @drugg1st What is a FE2? It is an open wheel race car originally produced by Van Dieman and now produced by SCCA enterprises. About the same performance as an SR3 1500, but lighter at 10...

My two 2021 SR3 XX have the colored buttons, but my FE2 is the newest wheel and has the black back-lit style. I don't know for a fact which is newer and I don't really think it matters, but the Aim w...

I bought a slave cylinder for a standard SR3 clutch from a dealer (who is now closed for the weekend) which is different than the Recluse slave cylinder which came out with my timed out engine. These...

Posted by: @parsonsj Call Spring Mountain, and they'll send you the freight box via UPS. You'll have to figure out how to put it together, but it's a simple job. Removing the engine, draining all flu...

My side skirts are about 52mm from the ground, both sides, so 33mm does sound quite low. I would start by establishing the actual chassis height (not ride height or drop height), measured from the st...

Posted by: @rjbender The only slightly tricky thing is checking/setting the 'free play gain' which is an adjustment that you make on their slave cylinder That is a fact. I spun and burned one of th...

The main problem was that the two batteries were unlinked, which caused drawdown in the main battery, also resulting in the charging system to be inoperable. I suspect this prevented the ECU from get...

Potential solution. Bad relay was causing second battery to not link with the main battery update. Car is fixed. New engine runs well. Three issues found and corrected. I’ll fill in details tomor...

The car has a cam sensor and it is plugged in. I swapped another main battery in this morning which I fully charged and it is a known good battery. When I turned on the master switch the volts read...

I think this is going to be a Charley question or someone who knows all of the SR3 models well. The SR3s that I have seen all use a round connector just in front of the dash and where the rear part o...

@charleyhradicalsportscarregistry-com will do Charley. I just collected an additional 46 second run by holding throttle. vbat starts at 10.42v, jumps to 13v while I am holding throttle, then return...

Posted by: @parsonsj Is the inlet air temp sensor in the air box? If so, was the temp sensor connected during your previous testing? Yes, the air temp sensor has been connected the entire time.

And the problem has returned. I am somewhat relieved because I need to determine the problem. I swapped in the TPS from the good car, and now it will fire up but dies after one second, which is the ...

The saga continues ... although some progress today: I installed the original throttle bodies that I had swapped to the good car (a couple weeks ago), set the TPS, installed the air box, fussed with t...