Liked Forum Posts
|
RE: Recommended tools and equipment for operating a Radical FYI - a couple updates on some tools. Found a great source for the special clutch 8mm bleed tool, much cheaper than Snap-On. As for the very difficult 3/4" nut on back side of rotor drive pegs on ... |
In forum Getting Started |
4 years ago |
|
Life ECU battery just a note, the ECU has its own back up battery. It is a rechargeable battery. A good practice is to power up the ECU once a month, doesn't neeed to run, just put some power on the ECU. I failed to... |
In forum Getting Started |
7 years ago |
|
RE: SCCA Log book inspections John, I am not trying to scare you, but it is worth reading (or re-reading) this post about Fuel cell age. The picture of my fuel cell (above) was take when the fuel cell was 7 years old, and it had ... |
In forum Getting Started |
6 years ago |
|
RE: SR3XX 1500cc oil cooler spec? My car is a lot older but this is what I have. Attachment : PXL_20220723_032100063.jpg |
In forum How To / DIY Discussions |
3 years ago |
|
RE: Something broke today Here is a very enlightening video about the Gen 1 Hayabusa clutch noise and rattling that I showed in my video. |
In forum SR3 Specific Discussions |
3 years ago |
|
RE: How does one go about crating and freighting an engine? @gabriel I am sorry, I do not. I referred to my other SR3 several times during the install. I am away this weekend racing (not Radical), but if you have some specific requests I can post pictures n... |
In forum How To / DIY Discussions |
3 years ago |
|
RE: Do yall drain air tank? how/where/frequency? use allen key access on bottom tank enough room to get into . some race cars have small hole and grommet fitted on bottom of side pod for easier location |
In forum How To / DIY Discussions |
4 years ago |