Richard Kosar

Mine has them also.

Yup, that's what I'm thinking about doing - and you are correct, both of my pipes have a rolled lip on the ends - easy enough to fix, as I've been fabricating stuff like that (and full vehicles) for y...

Ah, point well taken. I'm in an 8 with Michelins.

I have the “quiet” mufflers already but I’ll venture saying they need repacking. I also received a brand new set of standard small can mufflers from the guy I purchased the SR8 from on Friday - not en...

Posted by: David Corda How did you charge the battery for your winch that is sitting in the trailer? Start out by getting a deep cycle marine/RV battery (available at any auto parts store). The tend...

Toe in? I was told 1mm of toe out up front and 3mm toe in at the back by the guys from Spring Mountain.

Thank you, fbf. I went back and redid my camber settings after reading your post. I put two bags of bird seed and a bag of water softener salt in the seat (140 lbs) and 20 lbs. of billet aluminum in ...

How do you figure cross weights - for that matter, what is cross weight? Looks like I’ll be tossing a couple of bags of bird seed and some billet blocks into the seat and and floor and rechecking thin...

Talked to James and Bill at Spring Mountain today. I was able to get a lot of good base line setup info. Some of the settings on my car were close to what I've been given, some were a bit off. Front ...

Thank you Graeme, I’ve noticed those pieces. I plan on making a set of string bars next.

My scales arrived this afternoon and the car's ready to go other than the bodywork being on it. So this afternoon I loosened all the damper settings to fully open, (forgot to put the tires to hot pres...

Now that I have the seat moved as far forward as I can get it I worked on getting the pedals back a bit to a more comfortable/functional position. The throttle pedal has adjustable stops so I threaded...

Does anyone have info on the halo? All my searches end up directing me to either F1 and their introduction of the halo around the cockpit or medical devices to keep damaged neck/spine immobilized.

Charlie - thanks for the new section. I’ve owned an off road forum (minibuggy.net) for the past 6ish years (it was dropped into my lap) and have found that you’ll add as the forum grows. It makes thi...

Posted by: fatbillybob How do you prevent the 1st gear stalling? I get my 1st days in a Radical in 2 weeks. Is it a light flywheel low torque problem you just need to figure out? Ergonomics is key....