I am the Meatman! Self made and growing 🙂
This user account status is Approved

Forum Replies Created

RE: Something broke today

@rlm-dan The seal is installed now and thanks for the tip. I suppose I would have found that out eventually eh!

In forum SR3 Specific Discussions

3 years ago
RE: Something broke today

Almost ready to drop the engine and GDU backing, something I noticed during the dismantling process is that I was missing a few bolts (see pictures) I wonder where I would be able to get some of the...

In forum SR3 Specific Discussions

3 years ago
RE: Something broke today

Yup, good think I replaced the gdu oil cooler.... Good sized chucks coming out of it. Attachment : PXL_20220806_030052866.jpg Attachment : PXL_20220806_030048027.jpg

In forum SR3 Specific Discussions

3 years ago
RE: SR3XX 1500cc oil cooler spec?

My car is a lot older but this is what I have. Attachment : PXL_20220723_032100063.jpg

In forum How To / DIY Discussions

3 years ago
RE: Something broke today

Posted by: @charleyhradicalsportscarregistry-com @meatman, Ouch! Yah, you could even say that in capitals! lol

In forum SR3 Specific Discussions

3 years ago
RE: Something broke today

Conversation pcs for the wall of shame. Attachment : PXL_20220804_043202293.jpg Attachment : PXL_20220804_043208310.jpg

In forum SR3 Specific Discussions

3 years ago
RE: Something broke today

Posted by: @rich Looking at your Gen 1 gearbox, I hope you have a service manual on hand for plate and circlip direction (orientation to load) torque specs etc. Best of luck with your project, Ric...

In forum SR3 Specific Discussions

3 years ago
RE: Something broke today

And it begins 🙂 Attachment : PXL_20220730_135352707.jpg

In forum SR3 Specific Discussions

3 years ago
RE: Something broke today

Okay, I've got all my parts on order, my GDU has been rebuilt and I should be starting the reassembly next week. As I was getting organized on my workbench, I moved my clutch assembly off the one sid...

In forum SR3 Specific Discussions

3 years ago
RE: SR3XX 1500cc oil cooler spec?

Posted by: @parsonsj @gabriel Does the SR3 use a water to oil cooler? No it does not, it uses a traditional air cooler.

In forum How To / DIY Discussions

3 years ago
RE: Something broke today

Posted by: @charleyhradicalsportscarregistry-com With chunks that size going through your system I would consider changing your GDU radiator as well. Finding a direct replacement is tougher than...

In forum SR3 Specific Discussions

3 years ago
RE: Torque value and video

Well, lesson learned. Always check that everything is correctly torqued. Both sides were not even close to the 45ft/lbs. Is there a service manual available somewhere that I can get to check bolt t...

In forum Suspension setup and Handling discussion

3 years ago
RE: Torque value and video

@rjbender Thank you Sir!

In forum Suspension setup and Handling discussion

3 years ago
Torque value and video

Hi, does anyone know the torque value of the lower control arm arm bolts? Circled in the picture? I attached a short video of some playing this joint, I want to make sure it's torqued correctly befo...

In forum Suspension setup and Handling discussion

3 years ago
RE: Hello from France

Son of a BITCH, I know exactly how that feels.

In forum New Member Introductions

3 years ago
Page 10 / 18