Rod Bender

@azwcat - In my opinion 0.5mm difference will make zero difference in L/R brake balance. The distance the brake pads 'knock-off' the rotor face on both rotors should be the same, so there should be n...

@ntf3000 - that's the filter I think

Hi All, I've got a 2015 SR3 RSX (Chassis 981) here in Tasmania and I'm close to getting on the track for the first time. I've seen a few comments on the fuel cell 'life'. It's mentioned above in thi...

Posted by: @rjbender G'day Josh, ... this is in my post from a few days ago in this thread.... my solution for holding down the front... with next to no chance of pulling the alignment out. Here ar...

@johnannz - and here is what I was recommended to use by Radical Australia...

G'day David, I would agree with others here, that the best way to secure the car is using the D-Rings. I have used tie-down straps like the ones you have shown in your original post (although on a VW...

@gobble - good suggestion I think. Someone else will know for sure (I haven't driven my car yet... new to this too!), but I think if it's a fuel pressure problem you should be able to look at the dat...

Here's what my RSX had on it when I got it Attachment : Wolverine Pre-Heater.jpg Its a Wolverine branded external heat pad with a 250watt capacity. I note they also make a 500watt version.... I...

@gwt561324 - Thanks Garrett. Just to be clear, the Sunoco fuel I can get isn’t the GT 260.... its the oxygenated version called GT 260 Plus ... if I could get the GT 260 I would use it. ... see below...

@charleyhradicalsportscarregistry-com - G’day Charlie and others, Getting close to running my SR3 for the first time and trying to find a local supply of decent fuel (rather than pump fuel which seems...

@graemed - 😆 I thought you had found a novel way to keep rubber and other debris our of your radiator inlet!

@graemed - G'day Graeme, Is that an air filter on the intake to your left hand side-pod? ....??

@acey - great video and a good race until that moment. Could you tell us what camera you are using for that shot, and show us how you have it mounted to the car?

@mikesmith - the rubber strap you have shown, along with the fiberglass battery cover in the diagram is exactly the same as in my SR3 if that helps... and I would be happy to take a photo for you if i...

@gwt561324 - get some Teflon plumbing tape and wrap it around the lip of the seal. You might need more than 1 turn/wrap as you will need to get the Teflon tape to stick to itself well enough to hold ...