Rod Bender

@ meatman The Forum Search Tool is your friend... .. you are probably using the Motul 75W-140... others use the Neo-Synth 75-90... their are people that have used both and have developed a preference...

@jeff-alton ... Hi again Jeff, Dan Phillips at RLM is the likely person who might know.. but as I understand it, the new oil specification is focused on the new "-X" changes to the journal/bearing arr...

G'day @rojid I'm no fibreglass/composite expert so I'll leave it to others to comment on your repair plans. There does seem to be a fair bit of work involved.. have you considered buying a new split...

@jeff-alton ... agreed - it would be great to hear what the exact issue is they are trying to solve with this change in viscosity 'requirement'... I understand a little about lubrication, etc and I c...

@ezabala8 … I haven’t replaced any, but have removed a couple… from memory it was as simple as it looks. Once you’ve got the arm off the car and the upright, then remove the circlip and press the sphe...

G’day All, Thought I’d share this idea for those with OCD tendencies like me… I’m tidying up my brand new SR3 XX and was getting sick of getting copper anti-seize on me when working around each corner...

@charleyhradicalsportscarregistry-com Thanks Charley - I'm actually really only taking the opportunity to do some 'preventative maintenance' while I'm preparing to rebuild my car after a pretty big sh...

Hi All, I'm hoping someone can help with some advice or photos of their water pre-heater connections. I'm building a water pre-heater that will run on 240v supply and will include an off the shelf 2...

Hi @jeff-alton I experienced the same 'sensation' the very first time I drove my RSX, after racing karts and heavily modified road cars for 30 years... and I have others say exactly the same thing as...

@jeff-alton ... G'day Jeff. Just to be clear... keeping the revs down would have the opposite effect of 'helping'.... keeping the rpm lower will have the effect of limiting the heat generated in the ...

Ok.. its' me here again!... I took the Dremel to the gear change actuator and managed to make that work so I could get the wire retaining clip out... Then I've struck another issue... I can't get the...

@schneller You may have forgotten to attach a photo to the above? There’s some info here as well…

@schneller …I think you’ll find my design is extremely close to the Reverse Logic ‘progressive’ ramps. From memory (it was 6 years ago) I used some information from their website, along with some info...

@rlm-dan ... Thanks Dan. I was actually thinking about doing that exact 'hack' last weekend when I spent about 20 minutes trying to get something sharp under the end of the clip. (started with a jewe...

Hi All, Just doing some maintenance on my SR3 and wondered if there was a trick to removing this 'retaining ring' on the gear-change actuator? I can't find anything that will get behind the wire or g...