Last seen: September 21, 2025 4:33 pm
@azwcat My pleasure. With tires mounted, you could make an adapter that fits inside the perimeter of the wheel and either hold the gauge firmly a...
I do recall my lap times began trending lower after I applied these. 😀
That covers all of the pieces of the MK setup equipment. I am 100% satisfied and I had zero problems using all of it. I have no financial interest i...
The last pieces of the system is a wireless corner weight and tablet system from Longacre, which is integrated into the MK scale pads. The wireles...
I marked my shop floor where to position each tire, and also the location of the three adjustable legs of each scale pad. This needs to be done once ...
There are two corner weighting equipment systems in use -- one which uses ramps and weighs the corners with the tires mounted, and one that uses setup...
I really like the MK toe bars because they stay in place without moving around, and are easy to adjust side-to-side, making it easy to configure the t...
It is no problem to adjust the high speed bump compression and rebound with your fingers, but for the low speed bump I use a 4mm deep socket and twist...
Measuring camber could not be easier. I purchased this camber/caster gauge with a magnetic adapter: Then I found someone on Etsy.com who sells st...
The ride height or drop height measurement on a Radical is calculated from the distance between the top of the tires to specific points on the chassis...
The MK hoist is 100% awesome. I use it all the time, and I usually just store it in place over a car, however it folds up for hauling and has two ext...
First piece of equipment is the chassis stand on heavy duty casters. It is sturdy, rolls easily on a smooth surface and can even handle some bumps bu...
@rojid I don't know. I personally hate buying the same thing twice. You can use jack stands under the hubs; I used this for a couple of months an...
@rojid Yes, this is wide enough. My chassis stand is 24 inches wide, and it works well however because it is pretty narrow, I need to locate the rear...