I talked to the Hankook tire engineer today who said that the reason you should run your slicks in the correct direction for the first heat cycle is b...

Also be sure to loosen the adjusters for rebound, high and low speed bump all the way.

Hi John. According to my driving coach and Hankook, after the first heat cycle, it is fine to run the slicks in reverse rotation. I swap my dry tire...

I checked my scale start point when I last set my ride height. This is the starting point after doing all of the setup steps but before final corner ...

Hi Ron. I don't have an answer to solve this but I would probably first check your scale accuracy and ensure they are dead level. After I carefully ...

@tmpoquette Hi Trevor. I am not an expert on this data and camera stuff -- I learn just enough to get everything working, and then I kind of forge...

There is an old thread about anti-seize grease causing the wheel nuts to weld onto the interface of aluminum wheels, requiring the nuts to be removed ...

I always have. Many also run Neo Sythetics 75w90 which might be better? IDK. I think more important is to ensure the exact right amount is in your ...

260 foot-pounds

@rjbender Excellent point and idea Rod. I will see if I can fit a temp strip where you indicated.

@rjbender Hi Rod, Yes, these are what I have on my SR3 uprights -- Temp range B 71 to 110 C. I have reached 104 C on my uprights and beginni...

@parsonsj It begins with a driving sim cockpit which holds the screen, pedal set, steering wheel, keyboard tray and mouse, and is your seat. T...

I just switched from the SmartyCam 2.2 HD 2.2 to the 3.0. on the 2.2 my GPS09 plugged into the camera, and the camera plugged into a CAN hub. On the...

I use iRacing mostly, and Assetto Corsa for tracks that are not in iRacing. They are very helpful in learning the tracks and getting faster, but ther...

Below is a picture of the fuel cell foam being prepared for the fuel cell. This was from my 2021 SR3 XX which required a baffle upgrade to keep the f...