Hello I have a Sr3 with jenvey injection and it's hard to start when cold. My car is hard to start when cold even after 24 v conversion. If you mi...

I finally cut the ignition at the 2*87 connector of the relay and it works fine now

Today I tried to cut the ignition coil wire one by one and didn't find one cutting of the engine. 2 wires are signal but the 2 other wires don't stop ...

Hello Im installing a VAC robotics paddle shift system. The pneumatic actuator of the kit have a 40 mm stroke (+20mm and -20mm) I checked with th...

Hi Thanks for searching for me ! I finally found another solution. Keep this 280mm discs , Cleaned the bells where they are damaged and made 20 over...

my shafts looks ok they have new cv joints but the right one (the long one) needs few degrees of rotation before to engage. its hard to explain I wi...

does anyone know where to find this ?  

I would like to say a big thank you to Jim King because your help was great and I managed to convert my sr3 to a dual battery . thanks nico

Hi I compared the wiring with the oil temp sensor and now i can say that: wiring side of car wirind side of sensor yellow---------------...

Hi I compared the wiring with the oil temp sensor and now i can say that: wiring side of car wirind side of sensor yellow---------------...