Crotch strap harness position and mounting
i have a schroth enduro 2x2 6 point harness.
Can anyone confirm if this is a fairly standard way the crotch straps are mounted in your cars?
Because for me ..
1. there simply isn't enough gonad space (see purple section below!)
2. There isn't enough length. My seat insert raises me up (i'm 5ft 6) so there's even less length. As a result the buckle sits maybe a few inches lower than it really should be, and my nads are squished in all sorts of unthinkable ways. It was fine over the course of 80 laps but not ideal.
From pics iv'e seen hunting around this forum, it looks like the mounting position of the crotch strap is on a seat rail just behind the seat, and i don't know if there's further slack available or if i can bring the mounting forward somehow.
iv'e scoured the internet trying to find an optional longer crotch strap but no luck. What can i do?
@rojid, here is a picture of what the seatbelt connections look like under the seat. There is usually extra lengths of belting near where the belt connects to the frame. It is a bit hard to see in this picture but the extra belt material is rolled up and tie wrapped to hold it in place. When you remove your seat you can lengthen the straps as much as you need.
Unfortunately getting more crotch width clearance is a bit more problematic because of the limited width of the slot in the seat…
sorted 👍
wish i could put a nice tillet formula seat in here instead of the radical bathtub but looks like i'd have to fabricate bespoke mounting points somehow... bit of a project i guess.