Notifications
Clear all

No shift after engine rebuild

5 Posts
3 Users
2 Reactions
1,113 Views
Bryan Tatum
(@brewerbry)
Trusted Member
Joined: 1 year ago
Posts: 31
Topic starter   [#1717]

I hope this is a simple fix!  I had my engine and GDU rebuilt this offseason along with the Life ECU updated with a new battery and just re-assembled everything this weekend. 

The issue I am experiencing is that I am not able to shift gears.

The compressor is on and holds pressure, the paddleshifter levers do not initiate any response unless I have the neutral selection button pushed and when that is pushed, you can hear the pop of shifting gears.

I hope I just missed plugging something in during the re-assembly process and is a super easy fix but I have no idea where to start that search.

Any thoughts or suggestions?

Thanks!

Bryan



   
Quote
Bryan Tatum
(@brewerbry)
Trusted Member
Joined: 1 year ago
Posts: 31
Topic starter  

Disregard this message - after I got the engine started and running, car will shift normally.

 

now to figure out the transmission grind when I let out the clutch…



   
ReplyQuote
Dorothy Hong
(@rynhong)
Active Member
Joined: 5 months ago
Posts: 7
 

If it shifted fine before the rebuild, I'd start by checking everything that was disconnected or adjusted during reassembly before assuming it's an internal gearbox problem. Linkage alignment, shift cable adjustment (if applicable), clutch operation, and the shift actuator are all worth a careful look. Even something slightly out of adjustment can stop it selecting gears properly. Hope it's something simple!



   
ReplyQuote
Mr Macklems
(@mrmacklems)
New Member
Joined: 10 months ago
Posts: 2
 

Since this started right after the engine and GDU rebuild, I’d first check the electrical connectors and wiring disturbed during reassembly, especially the paddle shifter inputs and the ECU connections. The fact that you can hear the gear mechanism actuate when pressing the neutral button suggests the pneumatic system may be working, but the control logic or a sensor interlock could be preventing normal shifts. I’d also check for fault codes before replacing anything. What vehicle and transmission system is this? That would help narrow down the likely cause.



   
ReplyQuote
Bryan Tatum
(@brewerbry)
Trusted Member
Joined: 1 year ago
Posts: 31
Topic starter  

I will close the loop on this - I got it sorted out and have had a productive season with the car.  The issue was adjustment on the clutch slave cylinder - it needed adjusting after reinstallation.  The other small item was the reverse cable was not fully engaged or disengaged and caused a buzzing / whirring / wind up toy sounding hum.  Once clutch slave was adjusted and the reverse was fully disengaged, it worked great.



   
CharleyH and Rod Bender reacted
ReplyQuote
Share: