Crit Scholer

There is actually quite a lot of spider cracking over the rear wheels and on different parts of the rear clam and above the side pod. Doesn’t really show up in pics. I’m going to pull the clams and al...

It's shifting pretty well right now and I'm not competing so will probably leave it for a while. Geartronics sounds like a great company, wish they were stateside.

What's the operating temp on those hankooks? I have the michelins on my sr3 and have a hard time getting them up to temp for autocross.

@parsonsj Hi John! Thanks for writing and that’s awesome that you had the same setup I currently have. How hard was it to re-wire the system for the upgrade and I’m assuming quite a bit of track and b...

Charley, here's another wiring diagram for the car side but unfortunately radical sent the wrong one for my car, this one is likely for a Gen 2 and or FI car as the diagram is dated 2009. Attachme...

They wrote back with the wiring diagram. Here it is. Charley feel free to add it to the wiring diagrams. Attachment : Radical AMP12pinouts.pdf

The car can be seen at 7:58 in the video. Not my video, taken by a spectator at the event.

I wrote geartronics but have not heard back yet. I installed a gear position indicator (not geartronics) and had to leave the original factory connector on the car side disconnected because it wouldn’...

@charleyhradicalsportscarregistry-com Thanks for all the help! I'll keep in contact with Sean and Anthony and try to find a local fiberglass shop to get me an estimate. No worries Diego 👍

@charleyhradicalsportscarregistry-com radical Northwest in Sonoma which is only about an hour and a half away from me says they have a new rear clam, going to check that route first but if they want a...

@diegocuestas Hi, I'm not quite sure if the mounting points are the same. Charley might know.

Charley, thank you so much for looking into this! I will give them botha call tomorrow. Wish I would have talked to Spring Mountain about the tail section when I bought the car from them.

Figured it out and got it installed, looks pretty good in my opinion 🙂 For someone looking to install an aftermarket tach, tap into the radical dash wiring harness and use the power and ground and tac...

Is that radical UK?

Hi All, I’m looking for a SR3 rear clam in decent shape, mine is covered with spider cracks and missing fiberglass underneath and in the wheel wells. I have a Gen1 but I’m assuming all rear clams shou...