David Flynt

Awesome. Thank you Charley!

Posted by: @raider89 The center front diffuser pad has two 4mm hex head cap screws, but they dont want to back out when unscrewing and zero access to back side within the diffuser. The other four at...

Oetiker part number 1670042 (Belmetric part number CHPE33.1) , 33.1mm x 7mm is the correct size for the smaller end of the boot.

@rjbender Yes -- I get some tilt from the slope of my driveway, but at the track I am always hitched up to my truck when I load, and on a flat/level surface. The trailer has a gentle down slope in th...

nice solution and engineering Rod

You don't need a tilting trailer. What you need are sufficiently long ramps to reduce the ramp angle so that your front diffuser does not hit the ramp. A little bit of scraping the ramp will not hur...

@raider89 Hi Dan. Yes my car is an SR3 XX; I will confirm fit as soon as I receive the washers.

I think this sealing washer will fit the bottom and side fittings as well. I am going to order several myself.

ANHoseFittings.com may have a replacement seal, but I don't what size is correct for these fittings. edit: Based on measurement of the actual washer, the fitting, and the specs given for this part,...

Posted by: @raider89 all flat head allen screws Any updates on this? I asked a few techs at Sebring last week, particularly one who has built and worked on many Radicals for years, and none of thes...

Attachment : C5C54BA8-6410-497C-885A-CA8A8A4797D2.jpeg

Good price on Engine oil. 8x4L for $454.20 ($55.77 per 4L): MOTUL 300V 15W50 Newparts also has the MOTUL 90PA gear oil for $15.95 per 2L. (For fitment use 1996 Acura TL 2.5L gas) And MOTUL 660 brake ...

When I take my diffuser off, that bar remains fastened to the chassis, not the diffuser. It looks the bar (on an RS) stays attached the diffuser?

I have not seen an RS, but yes I have heard that it is different than the RSX an XX models. There are two M6 bolts for each side of the rear diffuser, and four M5 in the rear that mount onto a bar. ...

@raider89 That is strange. Scratching my head, and I don't have an answer but a possible idea for you: Sometimes I have to grind off the head of a button head cap screw if the Allen key gets damaged...