Luke Ellis

Considering difficulties with approach angles for loading radicals, damage in transit/insurance, controlling access if there are any delay's, weather protection, spares included etc mine was shipped i...

@pfichter i went with something like this, available from a few different places which allows you to use the various go-pro mounts, zero movement/shake up to 230k'h measured so far... Attachment :...

So for the sake of posterity...my research shows; Year Typical Wheel Fitted RS3 ID Notes 2020 Early SW4 proto SW4 Pre-XX launch 2020–2022 Radical OEM wheel FSW_R (8400207) Full XX launch peri...

Much apprecaited @radicaldave ! ah....your wheel is recognised as a SW4, mine is not...there must be a key firmware or upgraded hardware difference between our wheels as mine is an earlier version rec...

😤 @radicaldave ... connected the wheel again, that button takes me to the device screen (below) Attachment : image.png   The receive button (shown below) just returns the request f...

Hmm, thank you. i can connect to the wheel and its responding.. Attachment : image.png however i see no ability to view the data pages? Attachment : image.png if i try to 'recieve' the s...

@radicaldave Hopefully you can help me now…connected my wheel for the first time and other than rs3 asking for an access key, i couldnt see any ability to adjust the pages/sensors, can you please walk...

yes two heating pads to speed the mornings warmup, we have good access to power at the tracks we attend and the super fast warmup is handy!

I routed mine to the rear and the did same with the oil heating power leads with some ‘power con’ waterproof connectors to make life easy. Routing the lines is pretty straight forward and the diy brac...

Cant comment on the consumption detail sorry however.....I'm learning our radical SW4 is a little different, if you want to update the pages or setting on our wheels, you need a specific cable that pl...

Yup, exactly that 🙂

Assuming your heater unit operates the same as mine. the units pump is strong enough to circulate the heated water throughout the system. the pump heats very fast so I would not recommend running it ...

@rojid sure have, from cold, on a cold morning, it hits 70deg in well under an hour, unit is tiny, self contained and very easy to plug in/remove at the start of the day and between sessions... would ...

Managed to grab a few photos of the installed p1 unit today Attachment : IMG_6655.jpeg Attachment : IMG_6639.jpeg Attachment : IMG_6638.jpeg Attachment : IMG_6634.jpeg ...

Myself and a friend have these installed - I dont have a pic to hand but the quick disconnect reciever is installed between the body and the rear diffuser...ill get a shot when im next near the car.....