Forum Replies Created
|
Glam shots of my Prosport Attachment : R-168.jpg Attachment : R-106.jpg Attachment : R-262.jpg Attachment : R-150.jpg My buddy Jack came over the other day to shoot the car. Boy did he do a good job! |
2 years ago | |
|
RE: Hayabusa engine mounts for Clubsport My car had a carb engine, so I had to graft the Suzuki ECU/harness into the Radical chassis. Lots of wires and sensors. I found a color schematic and had it blown up and printed out on a poster size s... |
4 years ago | |
|
RE: Hayabusa engine mounts for Clubsport I installed a Gen2 Hayabusa into my Prosport. The previous engine was a Gen 1 Hayabusa. I was able to reuse the engine mounts BUT the countershaft did not align with the rear sprocket. The Gen 2 and G... |
4 years ago | |
|
RE: WTB : tire warmers Two blankets are 11x72 the others are 14x72 SOLD! Attachment : tirewarmer3.jpg Attachment : tirewarmer2.jpg Attachment : tirewarmer4.jpg Attachment : tirewarmer5.jpg |
In forum Radical Parts For Sale / Wanted |
4 years ago |
|
RE: WTB : tire warmers I have a set of used warmers that came with my Prosport so 13 inch wheels $500 shipped in the US SOLD |
In forum Radical Parts For Sale / Wanted |
4 years ago |
|
RE: Prosport Master Cylinders Thanks Charlie, I had it in my mind they were 1" and couldn't see the size on the side of the cylinders. |
4 years ago | |
|
Prosport Master Cylinders Does anyone know what size the brake master cylinders are on a Prosport? |
4 years ago | |
|
RE: Clubsport bodywork Frank have you seen this in Malta Facebook |
In forum Alternate Parts / Source |
4 years ago |
|
RE: New "Ask Phil" question on SR5 I always enjoy hearing from Phil. He really gives insight into Radical, warts and all. |
In forum General Discussion |
4 years ago |
|
RE: Clubsport bodywork I sent you a PM |
In forum Alternate Parts / Source |
4 years ago |
|
RE: Rear jack stands with the diffuser installed @trakmnky Thanks, I was trying to avoid leaving the front body work on and weighting the front. Right now I have the front off and using two spare wheels and a winch to ballast the front end. I have b... |
4 years ago | |
|
Rear jack stands with the diffuser installed I finally have a diffuser for my Prosport. Having never run one, I have a logistical issue on how and where to place jack stands under the rear of the car. I have a stub that sticks out of the diffuse... |
4 years ago | |
|
RE: clubsport spares Alvaro, Check this web page for a cross reference of parts. Radical Spares List - MTC Racing I believe the Prosport and Clubsport share a lot of parts |
In forum Alternate Parts / Source |
4 years ago |
|
RE: Easy way to load a Radical into a trailer Aluma has increased the choices they offer and I would suggest you look over the whole line to find the best one for you. I think mine is this, 7710-7712 Utility Trailer Models | Single Axle Utility T... |
In forum Towing / Trailers / Truck Discussion |
5 years ago |
|
RE: Single Axle Open Trailer My trailer is a 12 foot and yes I have to overhang into the tongue area a bit. Charley could probably give the length comparison between the Prosport and SR3 |
In forum Getting Started |
5 years ago |