Rod Bender

Plenty do in the UK without any issues. The charging system will cope with it fine so no problems. You have to be on top of the system as Lithium does not like being discharged (like a failed charging...

20 hours is not great!! Although I have seen a forward gear starting to wear after only a few hours. I guess once the metal is in the oil it probably speeds up the wear process, plus once the case har...

Fortunately I did not see much damage elsewhere. I will look into super finishing -- thank you for the tip. I found a tiny bit of steel on the bottom outlet fitting magnet, and similar amount on the ...

Just FYI - yall may want to consider FlexTape or associated products. Once applied, super strong. I have used both FlexTape and FlexSeal to reinforce some areas of the gel coat and offer protection ...

Just a couple of points to add. Yes some of the early SR3’s were available without GDU oil pumps but it was a problem. A pump and circulation is essential to GDU longevity. the other point is that th...

@rjbender I did not open up the GDU beyond the left cover, and I won't refresh this myself, but I will ask the tech and then report back. I was quite surprised that the ratio gears look like new, an...

@rjbender, when I got my first SR3 it had 13 hours on the engine and the time on the GDU was unknown. I was told by the seller that it likely had similar hours to the engine. At my first GDU oil cha...

I will guess that the louvers serve as a vent to release air pressure in the wheel wells which would otherwise create a lifting force, reducing downforce, thus reducing traction. That said, I know an ...

Yes, the wheel wells develop high pressure and the vents are there to relieve it to better allow the underbody to do it's work generating downforce. Same vents can be found on the GT3RS, GT2RS, and G...

@rojid, some people like to have a spare starter just in case the don’t react quickly enough when they spin. I have never heard of anyone bringing a spare compressor. it is a very good practice to st...

@sr10formetoo, Sounds like a fantastic day! I agree that once you take a Radical out on track you will never be impressed by a street based car again. There is nothing like driving a lightweight, hi...

I had my 'turn-over' day(s) for my SR10 with Radical Northwest over the last two days at Laguna Seca. I have never had the luxury of a full support team in an arrive-and-drive setting. It was wonder...

My car is 2021 SR3 XX. I just noticed the passenger side header from underside of car is actually resting on this engine casing bolt (not sure what that covers). Regardless, does not look right as a...

6 seconds, nice!! Next time you are at Spring Mountain take a look at my car(s). I probably will not pick them up until Jan/Feb. I went with Race Radio on both. Set up works nicely. Post some pic...

Hi @teamlorenz, you did everything correctly. The last step in the process brings you to a “Payment” section for a $0.00 charge. It gives you an option to cancel. It doesn’t matter if you use the ca...