James Andrews

The starter relay has a green fuse (30A?) - check that.It's mounted to the rear firewall in the engine bay in a rubber holster of sorts. there is actually a slot in the rubber under it for a spare fus...

mine has gone missing...Anyone have one they are willing to part with? (located East coast US)

If memory serves...Step 1 - remove the roll bars on either side. Step 2 - drill out the rivets of the section under the head roll hoop/bar Step 3 - If your engine mount bolts go through both the firew...

I'm replacing the engine on my 2002 Supersport with a stock 1999 bike engine. I was hoping the Radical savants on this forum might have some answers regarding what parts need to be ported over but wit...

@Ken, Thanks for the info on the baffle plate.I came across this air oil separator that also has an integrated coolant route to heat the oil. Two things that would presumably be very beneficial to a w...

Does anyone have a source for a K7 1300 Hayabusa engine manual?found it: I spun a rod bearing (Cyl 1) 🙁 and will need to know all of the internal torque specs.I also noticed the baffle plate was crac...

@charleyhradicalsportscarregistry-com 🍺 Cheers! Worked a treat, thank you.

@charleyhradicalsportscarregistry-com I'm following your steps for the GDU oil change and I'm not getting any oil to cycle through the cooler. I've tried rotating the rear wheels in neutral and in all...

@charleyhradicalsportscarregistry-com Fantastic on all fronts, that manual has all the missing torque settings I've been hunting around for and a discount is always appreciated! Thank you.

Hi @charleyhradicalsportscarregistry-com The owner's manual on the forum doesn't have that page, do you happen to have a link to the full manual that page is from? Lastly what oil would you recommend?...

Thank you!I have a Facet pump and it's pushing out about 3 psi so all good on that front.Good to know on the check valve, I'll have to see if mine has one installed.

I'm putting a 2002 Supersport back together and found that the return port on the tank has been blanked off. I know enough from bike ownership that return lines are only strictly needed for fuel injec...