Walter Hilderman

I have both sides as raw shafts and believe they are new. I will look for them and shoot you a PM.

For an RS look for sources of 95mm Land Rover Defender assemblies. The ones I ended up with bolt right in. Red and Clear variants. LED Rear Light 95mm Land Rover Defender

ok this is working well in the garage and I will be at a chilly event this weekend to test further. Heater from HotShot is the unit I am using. Its better in real life than the website and Ken at Apex...

@rojid just so happens I’m installing it this weekend. I’ll get some pictures and a summary up soon.

@davidf Thanks for for verifying. A 2" spacer helps clear the exhaust for sure and allows me to use the factory calc table which is based on 2 inches above the rear wheels. I think I will use my 8 foo...

Replying to this thread because it has the images in it I am referring to. Could be a dumb question, but why does Radical take to the time to mention and draw a "4 inch" bar in the guide when you are ...

@rjbender you're awesome. Very interesting! I disassembled my units this afternoon. Hand written values (that have mostly worn off) on the springs seem to indicate 500F / 550R. This is a little close...

I see the handbook now and its showing 450F / 550R. I always forget to look in the official docs before I look here!

Does anyone know what the factory spring rates are for the AVO's and/or InTrax units on a 2nd gen RS? There might be something written on the end of at least one of my springs but I need to disassembl...

Good to know! I might cut the straight alumn pipe, add some silicone joiners and implement a check valve from hot head. Attachment : check-valve-cv-pl-12.jpg

I have done an external blanket and welded a bung on to the swirl pot for an immersion element. Both are slow I don't love either method as it relies on the onboard water pump and too much human inter...

@rjbender THANK YOU!!

Wondering if an RSX or XX owner can grab a couple of quick rear diffuser measurements for me? See pict for the two widths I am looking for. Attachment : 3rdgenreardiffuser.jpg Inside measuremen...

@rjbender Thank you very much. I did not have the LifeECU/F88 pin out previously and that is helpful for sure.

Update: LifeECU data downloaded. The ECU thinks all is well. The air pressure sensor turns out to be ok. I now know the shift air, oil and fuel pressure sensors are all the same. The relay is also goo...