CharleyH
CharleyH
@charleyhradicalsportscarregistry-com
Admin
Famed Member
Joined: August 3, 2018 12:45 pm
Last seen: November 16, 2026 1:17 pm
Topics: 244 / Replies: 1722
Topic
Replies: 4
Views: 9500
Reply
RE: QUAIFE GDU issue

@lunatic, that is the problem. A good way to make sure the cooler is filled is to ack up the car and then rotate the rear wheels by hand u til fluid ...

5 years ago
Reply
RE: QUAIFE GDU issue

@lunatic, it looks like it is overfilled. Did you put in a measured amount, or did you fill it to the bottom of the fill plug? These units are a bit...

5 years ago
Reply
RE: SR3 RSX fuel pump ⛽️

Teddy, check out this post, it has the part numbers in it.

5 years ago
Reply
RE: SR3 RSX fuel pump ⛽️

Hi Teddy (@radicalracer29), yes I can dig through my notes tomorrow and get you the part number. The fuel pump is from an Audi and it cost ~$125.

5 years ago
Reply
RE: SR3 - Relay missing in charging system

@djw, I looked at several versions of the wiring diagrams and they all show having this relay. Some call it an "Alternator Isolator Relay" and some j...

5 years ago
Reply
RE: Hayabusa engine questions...reliability and rebuilds!

Hi Robert (@lunatic), The short answer is that these engines are under higher stresses and loads than their motorcycle counterparts. The 1500's have m...

5 years ago
Reply
RE: Hayabusa engine questions...reliability and rebuilds!

@nich, The Clutch push rod is under the clutch slave cylinder and transfers pressure from the slave cylinder to the clutch which is on the other side ...

5 years ago
Reply
RE: Nik links -- are they supposed to limit suspension travel?

@johnsopa, I asked Phil about this and he asked if you could send or post some pictures so he can see what is going on.

5 years ago
Reply
RE: Radical Photo Contest!

@johnannz, great pictures! I knew you were fast, but I didn’t know you were to fast to capture on film😀

5 years ago
Reply
RE: Radical Photo Contest!

I can already tell that this is going to be a tough competition!

5 years ago
Topic
Replies: 15
Views: 7012
Reply
RE: SR8 Chassis 42 Build

@joep, Thanks for the update! I am looking forward to following your build!

5 years ago
Page 43 / 132