@lunatic, it looks like it is overfilled. Did you put in a measured amount, or did you fill it to the bottom of the fill plug? These units are a bit...

Teddy, check out this post, it has the part numbers in it.

Hi Teddy (@radicalracer29), yes I can dig through my notes tomorrow and get you the part number. The fuel pump is from an Audi and it cost ~$125.

@djw, I looked at several versions of the wiring diagrams and they all show having this relay. Some call it an "Alternator Isolator Relay" and some j...

Hi Robert (@lunatic), The short answer is that these engines are under higher stresses and loads than their motorcycle counterparts. The 1500's have m...

They look great!

@nich, The Clutch push rod is under the clutch slave cylinder and transfers pressure from the slave cylinder to the clutch which is on the other side ...

@johnsopa, I asked Phil about this and he asked if you could send or post some pictures so he can see what is going on.

@johnannz, great pictures! I knew you were fast, but I didn’t know you were to fast to capture on film😀

I can already tell that this is going to be a tough competition!

@joep, Thanks for the update! I am looking forward to following your build!

Congratulations John!

Sounds like a lot of fun. I know a guy that is getting ready to put a twin (or triple) turbo diesel linked to a Porsche PDK transmission in an SR3 in ...

Hi @joep, Congratulations and welcome! I am looking forward to seeing your progress. What are your plans for the car?