Awesome. Thank you Charley!

Right, so this is the same as mine. Rivets everywhere except those two long flathead screws. Use a 5/32 drill and some upward force to remove the he...

Oetiker part number 1670042 (Belmetric part number CHPE33.1) , 33.1mm x 7mm is the correct size for the smaller end of the boot.

@rjbender Yes -- I get some tilt from the slope of my driveway, but at the track I am always hitched up to my truck when I load, and on a flat/level s...

nice solution and engineering Rod

You don't need a tilting trailer. What you need are sufficiently long ramps to reduce the ramp angle so that your front diffuser does not hit the ram...

@raider89 Hi Dan. Yes my car is an SR3 XX; I will confirm fit as soon as I receive the washers.

I think this sealing washer will fit the bottom and side fittings as well. I am going to order several myself.

ANHoseFittings.com may have a replacement seal, but I don't what size is correct for these fittings. edit: Based on measurement of the actual w...

Any updates on this? I asked a few techs at Sebring last week, particularly one who has built and worked on many Radicals for years, and none of thes...

Good price on Engine oil. 8x4L for $454.20 ($55.77 per 4L): MOTUL 300V 15W50 Newparts also has the MOTUL 90PA gear oil for $15.95 per 2L. (For ...

When I take my diffuser off, that bar remains fastened to the chassis, not the diffuser. It looks the bar (on an RS) stays attached the diffuser?

I have not seen an RS, but yes I have heard that it is different than the RSX an XX models. There are two M6 bolts for each side of the rear diffuser...

@raider89 That is strange. Scratching my head, and I don't have an answer but a possible idea for you: Sometimes I have to grind off the head of a...