Dan Millsaps
Dan Millsaps
@raider89
Reputable Member
Joined: October 13, 2020 6:35 am
Last seen: October 24, 2023 6:28 am
Topics: 40 / Replies: 156
Reply
RE: Need advise: something weird happening after engine rebuild

UPDATE: I got consensus replies noted below from both Sean and Dan which are super detailed and helpful. I will work with my local dealer for resolu...

2 years ago
Reply
RE: Need advise: something weird happening after engine rebuild

Some additional clarifications: this was an intermittent issue/concern. I ran 4 sessions, it occurred in 2nd, 3rd, and 4th sessions, a couple times ...

2 years ago
Reply
RE: Need advise: something weird happening after engine rebuild

I found one of the hiccup spots, make sure you have sound on. Just exiting turn 1 at Cota upshifting from 2nd to 3rd. This was typical for the other...

2 years ago
Reply
RE: Need advise: something weird happening after engine rebuild

I will be digging into data this week. I agree with your comments about gearing, no changes on my part, and my run experience prior with Cota is simi...

2 years ago
Reply
RE: Need advise: something weird happening after engine rebuild

(@davidf) Have you experienced this with your new rebuild?

2 years ago
Reply
RE: Help again: clutch problem

I did not look that close because I drained the oil and it was full of metal. The clutch bearing split prompting full engine rebuild. A few bad par...

2 years ago
Reply
RE: Oil Analysis "Analysis"

See attached Radical technical bulletin from Feb2022, it identifies the new 60W oil recommendation. My 1500cc engine just returned from SM after a re...

2 years ago
Reply
RE: Bearing failure

Interesting, mine arrived 2 weeks ago to dealer shop. I dropped off my car last week, but I did not stick around for opening of the crate. Mine shou...

2 years ago
Reply
RE: Anyone with Radical Rental Prices

I paid ~$3200 for a single day at COTA a couple years ago (3 x 30minute sessions). That was in an older SR3, not properly fit, old tires, and minimal...

2 years ago
Reply
RE: SR3XX 1500cc oil cooler spec?

Nope, never did. My engine is out at SM for rebuild right now. When I asked dealer for more information about aftermarket vs Radical preferred brand...

2 years ago
Reply
RE: First 6hr Service on SR10 - Lessons Learned

David, you bring up an interesting point about the actual rollers. I watched a local Radical dealer service an axle at their shop to learn before I g...

2 years ago
Reply
RE: Compressor Receiver Water Drain Interval

I was instructed by local Radical race team to drain the small tank regularly, especially if located in hot humid coastal area. They have done it for...

2 years ago
Reply
RE: F1 Style Halo / Center protection

Nope, I was wanting the prior box similar to Revolution, oh well

2 years ago
Reply
RE: Help with data problems on new Radical

Interesting, my early SR3XX #1319 chassis has always worked well with regard to AIM. All seems functioning and interacting with steering wheel proper...

2 years ago
Reply
RE: Load vs Run Time for Service Intervals

I have gotten into habit of changing engine oil and GDU every other HPDE weekend (4 track days with 4 sessions each). Depending on the weekends, rain...

2 years ago
Page 2 / 11