Crit Scholer
Crit Scholer
@crit
Estimable Member
Joined: August 23, 2019 2:01 am
Last seen: November 30, 2021 6:58 am
Topics: 45 / Replies: 190
Reply
RE: 2008 SR3 - just purchased

@m22ble, you have a closed loop system, send them the same picture that you sent me of their GCU showing the GPI-4 sticker and they will make sure to ...

6 years ago
Reply
RE: 2008 SR3 - just purchased

Hi Sam, good news and bad news. Bad news is my software won't work, good news is you have the later designed closed loop system that is a lot safer as...

6 years ago
Reply
RE: 2008 SR3 - just purchased

Hi Sam, good news and bad news. Bad news is my software won't work, good news is you have the later designed closed loop system that is a lot safer as...

6 years ago
Reply
RE: 2008 SR3 - just purchased

Hi Sam, does your car have a LIFE ECU or MBE system? If it is MBE you car likely has an open loop geartronics shifter setup and I have the tuning soft...

6 years ago
Reply
RE: Pedal Extensions?

@achilles99, yup, just a standard piece of bar aluminum.

6 years ago
Reply
RE: Pedal Extensions?

@achilles99, picture is worth a thousand words right? Let me know if this is what you're looking for.

6 years ago
Reply
RE: Pedal Extensions?

@achilles99, just sat in the car to verify, gas pedal is even with the brake, the clutch is about 1 inch behind the brake.

6 years ago
Reply
RE: Looking for the cover that goes under the front clam. See picture

@johnannz, I've run it at an abandoned military base on the old runways and taxiways and it's probably because the surface of most tracks are a lot cl...

6 years ago
Reply
RE: Pedal Extensions?

@achilles99 absolutely no flexing. If Bill can't make one, I can fabricate one for you. Just give Spring Mountain a call and ask for Bill.

6 years ago
Reply
RE: Is this a standard part that my SR3 is missing?

@charleyhradicalsportscarregistry-com Thanks Charley, I'll post in the wanted section. I'll also check with Spring Mountain and see if the part can st...

6 years ago
Reply
RE: Pedal Extensions?

@achilles99 Here is the throttle extension. Bill bent a piece of bar aluminum and then riveted it to the pedal. Works great

6 years ago
Reply
RE: Pedal Extensions?

@achilles99 Hi! I’m 5’6” and Bill at Spring Mountain fabricated a gas pedal extension for me. I’ll shoot a pic tomorrow.

6 years ago
Reply
RE: air shifter problem 2015 SR3

@tmpoquette Glad they were able to get it sorted for you! What are some of the safety concerns they found?

6 years ago
Page 8 / 16