Crank sensor is not showing there in John's picture, it bolts to the two points just above the Blue oil gallery plug. It is the same as replacing the ...

Alan, Crank sensor is standard Hayabusa, they only normally show problems when either the wire is damaged or the sensor is damaged due to heat/debris ...

Congrats on the purchase John! The Life ECU will do both a datastream for AIM and Stack so I would like to think that the Stack is receiving a CAN str...

Just a bit of advice, the adaptor that you list above that goes from Supaseal to OBD is not one that will fit a Radical on MBE. If its not on your car...

Check the actuator setting and ensure that moves freely. Same with the blipper that it moves freely, sounds like it could be something with heat. As C...

Hi Nikolay, Just to add to the above have you checked the setting for your actuator? It could be that the actuator is not moving enough for the down c...

Fascinating to see this Charley, amazing how much standard spec, optional extras and pricing has changed over the years. Impressed you are finding thi...

What do you need to know exactly Joseph? The gear position sensor is internal and fits in direct replacement for the OEM item.

As John says its a Tilton double plate item. I can get you the part number on Tuesday if needed.

I agree to extent, if you look behind the oil filter on your engine you will notice a allan headed restrictor jet. This forces an amount of oil around...

I think it is important to ensure that you are reading the temperature of the oil that is being fed into the engine. On a wet sump the oil in sump pan...

As Charley says the dry sump tank has oil temp in the tank. Dry sump plumbing is different and all oil runs through the oil cooler before returning to...

I think it is a case of removing/loosening the side pod to get to it unfortunately. In addition to what has been said above the fuse/fuse holder in th...

Testing tomorrow for a few of the teams and then race day Monday. The races will be streamed live and can be found by following this link: First rac...

Hi Brandon, Actuator is the correct side of the gear lever which is good. With regards to the setting of 166mm this is with the actuator bolted to the...