@gwt561324 Garrett...thanks. That is what we ended up doing. We managed to coax 800ml out of the lower hose. The fluid coming out didn't look too wo...

@gwt561324 What is the secret to draining the GDU?

@raider89 These guys....

Garrett...here are the things that I just picked/borrowed/used over the last few months and have been happy with them. For scales I used these and w...

Excited to be running with you guys. Look forward to meeting you.

Perfect timing for this post! Heading there in December!

I know that what you said about rebuild time based on 'run time' not 'on-load' time as that is stated in the manual. But after reading Charlie's and R...

Here is what I bought. 1. Front lift jack.../p> 2. Lift Stands... /p> 3. Not sure on that...I just set mine on some plastic saw horses. 4....

@graemed Graeme...perfect! This is an excellent write-up. Thanks for taking the time to write this down. I am sure this will be referenced for years...

@azwcat...after having just been through this entire process, I would have to agree with the method outlined by Graeme above. I had all the exact same...

@graemed Thanks Graeme. So if I understand this correctly, I should set the front ride height as low as feasable and then take the rake setting of 1...

@azwcat I am new to this also so take my comments for what they are. The ride height is measure using a bar over the tires and measured to a fixed p...

Welcome Jim!

I worked all week to get a new setup on the car. I went with the Hankook 'recipe' from the manual and I must say it was a good starting point. There a...