Oh crap.... I'm.working in it right now....

Getting along..... But what is this doo Hickey for?

Alrighty.... all done and ready to drop it in in the the next couple days!

Anybody have suggestions on how to tighten the sprocket (output shaft) nut? I know it's supposed to be 105 ft/lbs but the shaft spins even in ge...

Thanks Dan! That's what I needed to hear!

Hopefully I get a quick response tonight on this question... I am installing the clutch and notice the spring washer and the spring washer seat ...

@davidf Thanks for passing the info along.

I wonder if this 15/60 is what I should be using in my older engine?

@rlm-dan The seal is installed now and thanks for the tip. I suppose I would have found that out eventually eh!

Almost ready to drop the engine and GDU backing, something I noticed during the dismantling process is that I was missing a few bolts (see pictures) ...

Yup, good think I replaced the gdu oil cooler.... Good sized chucks coming out of it.

My car is a lot older but this is what I have.

Yah, you could even say that in capitals! lol

Conversation pcs for the wall of shame.