Victor Ling

Update: I removed the engine this weekend and found the instructions in the Mechanics Manual to be quite complete. Below are my only additional suggestions: 1. Use a slide hammer to remove the engin...

Engine can come up or go down dependent upon what you use to remove it. Strip all the cable ties off, water and oil dumped. Three oil lines underneath (scavenge, feed and pressure sensor) and the cran...

@azwcat, I will do a full write up soon. But to answer some of your questions... the primary external changes to the body are the larger side pod inlets and the use of the Rapture nose (which is diff...

Posted by: @azwcat @tommymills, thanks, I missed the page on car setup in the manual. Looking it over, I think you got the sequence correct. It is interesting that the front splitter height seems t...

On my SR1, the splitter was fixed at the center mount in the crash structure. The side rods were adjustable, but that only twisted it to even it out side to side. But the front center would remain the...

@azwcat BTW, the pass in the gravel was not my choice 🙂 I was in survival mode!!!

@azwcat, it should be but depends on your current setup. Please consult with geartronics to confirm that they can make a plug and play setup for you.