CharleyH .

I started with West Systems epoxy which bonds well to the polyester resin parts but it takes some extra sanding to get polyester gel coat to cure over epoxy. I now use polyester resin for all Radical...

Hi Helmut, Dan will be the best one to comment on the engine issues, but in relation to your AiM dashboard question above... this happens sometimes on the cars I have owned. It seems to be caused by...

Could you please send me over the data files from these drop outs Helmut and I will take a look for you. Dan@rlmracing.com

@dwang2000 that is just messy.. why you wanna put it on dollies? Just simply tilt your trailer and add long enough ramps.. this simple. If you cant tilt your trailer like i do, Attachment : 1DF4...

I thought this might be the best place to share my ramp setup to get the radical up on my four post lift. I used 1/2” thick board ripped the width of the ramp in lengths of 6 inch increments and stack...

Ditto what David said. Most likely the scales are not set correctly being perfectly level, or a scale itself it not going out. Check and make sure no wires to the scales are pinched. Also make sure th...

Also be sure to loosen the adjusters for rebound, high and low speed bump all the way.

I checked my scale start point when I last set my ride height. This is the starting point after doing all of the setup steps but before final corner balancing. LF/RF/LR/RR(pounds): 204.6/407.4/514.8...

Hi Ron. I don't have an answer to solve this but I would probably first check your scale accuracy and ensure they are dead level. After I carefully set my ride height, I am typically way off on the ...

I talked to the Hankook tire engineer today who said that the reason you should run your slicks in the correct direction for the first heat cycle is because there are structural elements that run diag...

Hi John. According to my driving coach and Hankook, after the first heat cycle, it is fine to run the slicks in reverse rotation. I swap my dry tires left to right after 3 or 4 cycles to keep the we...

@tmpoquette Hi Trevor. I am not an expert on this data and camera stuff -- I learn just enough to get everything working, and then I kind of forget about it. A couple of things to pass on: - each t...

I just switched from the SmartyCam 2.2 HD 2.2 to the 3.0. on the 2.2 my GPS09 plugged into the camera, and the camera plugged into a CAN hub. On the 3.0 there are only two cables which plug into the...

I always have. Many also run Neo Sythetics 75w90 which might be better? IDK. I think more important is to ensure the exact right amount is in your GDU. Too much and it will spray out of the breath...

@davidf Thanks for the info on the Molykote. I've never liked using anti-sieze on wheel nuts for the same reason you don't (and not just ordinary dust; brake dust!). I ordered a can of it just now.