CharleyH .

Issue appears to be the crank position sensor wire (1 of 5 wires) in the bundle came loose on the motor. So going to remove the side cover and try to reattach Attachment : 2319119130046895166.jpg

@jamesmcga I agree with Charley, The answer will be in the Life data. ... I'd check fuel pressure first. It should be shown on your dash (AiM MXL2 has it, not sure about AiM MXL?), but it will de...

As Charley noted with the pin connector sometimes being a culprit, I had some problems with mine as the car aged. I converted it to a Deutsch style plug and: Solid connectivity with no accidental plu...

@cwrega The "NoRTC" is highlighted in blue at the very top of your screenshot. Charley is dead on about the battery. I had mine replaced after it died but I know others just use the Aim Studio 3 soft...

this thread of mine provides lots of useful info on this: you have to remove the sidepod to get to the compressor so that would be a total PITA on a track day...i bought the higher-temp-resistant li...

Attachment : IMG_2361.JPG Attachment : IMG_2355.JPG Attachment : IMG_2358.JPG Attachment : IMG_2366.JPG Attachment : IMG_2364.JPG

@rojid I think the straps are 2 feet long (I don't have them anymore), called axle straps and available at stores like etrailer.com. yes

I think I have done it both ways, and I don't think it is critical, but use your best judgement on what you think is safe and secure. Here are a couple of pictures: Attachment : engine 2.jpg ...

Hi Philipe, A wet sump engine will in general run hotter than a dry sump due to the oil being stored within the engine - with the dry sump tank there is some cooling just from having the oil out of th...

I got sick and tired of the cable never really working well. I will make some labels for each button but for now the far right (#4) button I push for 5 seconds and reverse gear happens. Button to t...

Thanks this is very helpful information.

Hi Paul, where are you located? I can tell you from personal experience I wouldn't get anything shorter than an 18' for an enclosed trailer. at 16' you won't have enough room to maneuver your body aro...

@rlm-dan and @prschmn ... maybe this could help? I found it useful as it lists all the part numbers... including the pushrod numbers (and length), plus what spacers and bolt hardware is required for ...

This is likely to be what you need: Radical dealers will have them or you may find a used one about out there. Just be careful with spacers and clutch push rod if its needed as there were a few dif...

I have the Futura Super Sport (16'5 deck) and it works great. I believe the deck angles down to about 3 degrees. What I used for the Radical I used with my Cayman that has a very long and low splitter...