CharleyH .

No worries John, just let me know if anymore info is needed! Just wanted to make sure I was not causing any confusion with temps.

@charleyhradicalsportscarregistry-com it's 00828 and it's a 1500. NY sounds like a place closest to me, maybe I'll give them a call. Thank you!

As Manny said but if you are checking the stator output on the 3 pin plug then you need to be doing this in AC on your multimeter. You should then check all three options over two pins if that makes s...

Posted by: @rlm-dan Hi Brad, It is indeed a OEM Suzuki crank sensor and one from any year will fit. Unfortunately Suzuki only sell the sensor complete with the alternator windings so you need to buy ...

Just thought you might all enjoy the sound of a 1440cc Hayabusa engine singing on the engine dyno. Attachment : 7dd2d86c-6424-4394-acd7-1538f327b386.MP4

Posted by: @parsonsj @rjbender Love it! I'm stealing your idea! Similar to that, I use the AiM LEDs on the dash (I have an MXS 1.2). Solid Red is too low, slow flashing is too high, and fast flashing...

Hi Brad, It is indeed a OEM Suzuki crank sensor and one from any year will fit. Unfortunately Suzuki only sell the sensor complete with the alternator windings so you need to buy this complete assembl...

@rjbender, in my case I put the heat pad on the swirl pot and added a power pigtail to the water pump so it can be energized by my CTEK charger in supply mode (just like you do for fuel pump out) in o...

Yes -- me too: on the roll bar tube. I've seen them done on the backs of mirrors though that's on gel-coat rather than the powder coat of the tube.

I put my on the roll bar stays typically (if they require them). So far there haven't been many Radicals out at days like that and the staff tend to remember you.

I use an Aluma, all aluminum, trailer for my Prosport. The trailer weighs 550# but hauls 3500#. It has a beaver tail and retractable gate/ramp. I use a winch for loading and tow with the wife's miniva...

Hi , I will be doing some hill climbs soon and are wanting to know the best methods of getting a SR3 off the line the fastest from a standing start. With the least amount of potential load damage? Ple...

@parsonsj - great information John. I'm not sure if anyone else would be interested, but as another 'new owner' (used my car for the first time last month) I made and laminated a label for the dash ...

Good to see that the compression test results are good - I would still be interested to see bore scope pictures of the edges of pistons. Oil usage isn't on the high side at all. I am with Charlie and ...

New set of plugs are in. We will balance the throttle bodies and re-test exhaust temperatures.