David Flynt

I swapped out my timed out engine for a factory new engine last week. I added fluids, dry-cranked the engine until I saw oil pressure come up (30+ psi), and then tried to start it. The behavior is t...

Welcome Clark. It is a small world. I live in Tennessee but I am also a member of VIR and I know Danyel and his team well. I also have a steep driveway from the street. A couple of 2x10s and wood b...

I was a little worried that this would be a big job, but it went quite well on my SR3 XX. I left the radiator connected to the side pod, and disconnected two water lines and two electrical connectors...

Posted by: @raider89 The hex insert bolt that secures and holds the brake pads in place ... Which bolts are you referring to? I always remove the entire caliper from the chassis uprights and discs ...

Several of the Radical dealer techs have told me to replace when the pad thickness is less than 5mm. So if any part of the pad is less than 5mm, I replace them which means that I usually replace the ...

I am by no means an expert, but I recently purchased a syncrometer and balanced the throttle bodies on two SR3 XX 1500cc. Although the owners manual does not give a step by step procedure, I did find...

Posted by: @rojid Would it be quite easy to repair these holes? Can i just apply some sort of fibreglass filler compound? I just removed the entire half of the fiberglass panel under the roll bar t...

I have raced my SR3 1500cc in P2 class at an SCCA event. It depends on the event, but often there will be a mix of Formula Atlantic, Formula Mazda/Mazda Pro, Formula Enterprise, Stohr, Elan DP02, and...

“As we reach this milestone it is good to take a moment to look back and see where we’ve come from. Charley’s depth of knowledge is second-to-none, and his passion for Radical runs deep. We’re thrille...

Very clean SR3 Seth. Congratulations and enjoy!

Has anyone swapped their lead acid batteries for lithium motorcycle battery? Specifically, for SR3. Does or will the stator keep a 12V (12.8V?) lithium battery charged? Any problems or issues to kn...

Zoro.com link:

@parsonsj Various places sell these including Amazon. I cannot remember where I purchased mine, but these are all the same as long as the size is the same. The OEM part number I think is 25-07. Spe...

In my experience: You don't have to ratchet down crazy tight If you over tighten the strap, it could bend a rod end or upright. I would much rather have my car roll back and forth a couple of inches...

Attachment : IMG_6585.jpeg