Josh Spray

@rlm-dan dn, panic setting in LOL

What the heck in a balance weight shaft? LOL

Oh crap.... I'm.working in it right now....

Attachment : PXL_20220910_061006651.jpg

Getting along..... Attachment : IMG_20220909_203951_01.jpg Attachment : PXL_20220910_035516897.jpg Attachment : PXL_20220910_041000077.jpg But what is this doo Hickey for? ...

Alrighty.... all done and ready to drop it in in the the next couple days!

Anybody have suggestions on how to tighten the sprocket (output shaft) nut? I know it's supposed to be 105 ft/lbs but the shaft spins even in gear.

Thanks Dan! That's what I needed to hear!

Hopefully I get a quick response tonight on this question... I am installing the clutch and notice the spring washer and the spring washer seat were not installed when I dismantled it. As far as I c...

@davidf Thanks for passing the info along.

Posted by: @davidf I just received my 1500 refresh back from Spring Mountain today. Inside is a memo that says "This engine has been fitted with the updated input shaft. This engine MUST now be run...

@rlm-dan The seal is installed now and thanks for the tip. I suppose I would have found that out eventually eh!

Almost ready to drop the engine and GDU backing, something I noticed during the dismantling process is that I was missing a few bolts (see pictures) I wonder where I would be able to get some of the...

Yup, good think I replaced the gdu oil cooler.... Good sized chucks coming out of it. Attachment : PXL_20220806_030052866.jpg Attachment : PXL_20220806_030048027.jpg

My car is a lot older but this is what I have. Attachment : PXL_20220723_032100063.jpg