Nikki Schumann

Beautiful job on the seat insert... I love the Alcantara covering ! Also if you haven't thought of it yet, especially if she's used to Karting, a spin-safe clutch might be a good investment... it's th...

Posted by: @davidf I have heard that if one over-tightens the tie down straps, it can move the alignment or bend arms. I don't have first hand knowledge as I am new to tying down and towing, but I w...

Are there no labels on any of them ? The two SureSeal connectors are probably just available entry points for sensors (they look like they could be brake pressure sensor connectors - that's what they ...

Posted by: @meatman Posted by: @nick02 What looks like a MAP sensor is actually the BAP sensor on the firewall... I would imagine your ECU is a Life Racing... Should that not be wired into some...

From memory 30 degrees IIRC... OEM 1 and OEM 2 seat benches should have the same angle... The only difference should be the sides which come up higher on the second series and have a hole through whic...

Posted by: @rlm-dan Is the current MXL2 a data logging dash? as Dan says... Check if it's a logging dash, in which case you should be able to purchase just the second part of the loom from AIM and h...

Posted by: @meatman And this heat sink looking thing is the only item screwed to the firewall. Attachment : IMG_20200826_070904.jpg The heat sink thing is the charge regulator.

What looks like a MAP sensor is actually the BAP sensor on the firewall... I would imagine your ECU is a Life Racing... In your last picture, the pressure sensor on the brake line is the brake light s...

That's amazing... Thanks Charley... To think that this was only 22 years ago !

I had that switch go bad multiple times on SR3's... When brake lights don't work it's the first item I look at these days... Sorry I did not see the thread earlier to help on locating it. Regarding pr...

I didn't have time to take pics of the fuel pressure regulator today but the car is on track tomorrow... I'll try to take some then.

@crit here are pictures of the BAP sensor location on my updated 1500 Gen 1: Attachment : IMG_2210.JPG Attachment : IMG_2212.JPG Attachment : IMG_2211.JPG

@crit my earlier car (376) is a Gen 1 with the Life Racing ECU mounted behind the metal plate on the engine firewall (same place as the MBE usually was)... From memory I'm pretty sure the Baro sensor ...

Super read... Thank you Charley and Phil for being able to share this with us. 🙂

Attachment : IMG_2143.JPG This is the battery I pulled out of the RXC Turbo 500 that's in our workshop. Unfortunately I don't have the exact measurements at hand...