John Parsons

I ordered a 2022 SR10 due here this month. Ran an SR3 for a day at Sebring with Team Stradale was a blast. Have never been in an SR10 my background is in Shifter Kart racing and tracking GT cars. Chri...

@darrahc - G'day Clark, That looks ok to me. You might want to get the front of the car as far forward as possible to make sure the centre of gravity for the car is close to the trailer's axle cente...

Thanks, Charley! Don't worry, I'm sure I'll be asking a lot of questions! @parsonsj - would love to make it down to Sebring. I was down there years ago for a NARRA event and loved it! @bill-snead - ...

John, you need to drive the SR10 and write up a real world comparison!

Thanks for the info. After a lot of internet searching and actually speaking to real people! I have found that over here in the U.K. a complete assembly is a FG1079-12B1. Got to say, it has not bee...

Attachment : Fuel.jpg Attachment : Fuel 3.jpg I just posted this on a fuel pump thread.....but realised the thread is 2 years old! Prob best to post a fresh one.... My fuel pump from my SR3...

@parsonsj aye that was my first thought, to get the aim patch cable and camera (which oddly enough, they sell for considerably more than a camera which they themselves recommend and link to in amazon,...

Thank you for the thoughtful replies. I've decided to go with the SR10. Although I do love the look of the RXC I think the 10 will be a better track day car based on your replies and some conversation...

The Steeringwheel is modified Sparco F10A with ECU master 5" display, running on CANBUSincluded laptimer, Live data for engine parametres, 8 settings Traction control knob, 8 setting turbo boost/power...

You may want to consider Schroth SHR Flex, then angle does not matter. Can drive formula car or GT car with same device.

I've seen mine loosen occasionally when torqued to 260 ft-lbs. I think it has more to do with the temperature of the system when the torque is applied. When I torque in the shop and everything is cold...

Posted by: @rojid Would it be quite easy to repair these holes? Can i just apply some sort of fibreglass filler compound? I just removed the entire half of the fiberglass panel under the roll bar t...

2018 SR3 chassis number 1156 showed up this morning from Radical Northwest. I did the Primal three day school in the SR1 at AMP in December and was hooked and had to have one. Purchased this a month l...

I have raced my SR3 1500cc in P2 class at an SCCA event. It depends on the event, but often there will be a mix of Formula Atlantic, Formula Mazda/Mazda Pro, Formula Enterprise, Stohr, Elan DP02, and...

“As we reach this milestone it is good to take a moment to look back and see where we’ve come from. Charley’s depth of knowledge is second-to-none, and his passion for Radical runs deep. We’re thrille...