John Parsons

@gordon513 I coated the headers and the rest of the exhaust in my SR8 RS. The coating on the left side header has flaked off a bit, so I'm going to have it redone. It's expensive (about $800 USD), and...

@davidf I rarely bleed just to pull air out of the calipers, so I don't really know. When I do bleed, I drain the master cylinders, and put in all new fresh fluid. I use a Motive Power pressure bleede...

@meatman That's certainly not my experience. I use Castrol SRF and typically only bleed brakes when I change pads (2-3 times a year) and/or rotors.

@sodds sorry! My bad. I’ve dropped all my Stack in the bin. It’s all gone.

@rjbender I love your idea. (my issue is dropping the car on my foot. I'm not so smart, as I've done it more than once. It's pretty easy to put one's foot directly under the front tire when lowering t...

It's a dirty job, that's for sure. It's the grease between the needle bearings that need to be periodically changed. Most of the grease on the outside of the bearings just goes along for the ride and ...

@rojid @davidf The massage technique mentioned above is to put a dollop of clean grease into the palm of your hand, and then continually push that dollop through the needle rollers until the grease on...

Ah yes. We Americans and our antiquated methods of weights and measures. It's a bump from 710 to 720 kgs. 🙂

Others have mentioned this issue of heavier body panels. I've been told that Radical no longer makes their own panels due to persistent complaints about cracking, etc. Wonder if the sub-contractor has...

@meatman Ah, yes. That should work really well. Good luck with it!

@clark-darrah I really had fun there, and I hope to get back there soon. I've sent my injectors off for service, and I'm hoping to hear that they were a mess -- if not, then I'm not sure what the next...

@tmpoquette Yes, I saw the dust when the BMW went off-track ahead of you. I'm just amazed the corner workers didn't black-flag the session. And I hear ya about a long way to go! I've got a 1:57 to sho...

@clark-darrah @tmpoquette What's the story of leaving a car at the end of the braking zone at 11??? You had to have lost 2 seconds tip-toeing through there, not to mention the inherent dangers! Anyway...

@meatman Engine speed seems likely. You'll need to connect your AiM dash to the Life ECU CANbus for engine speed (along with gear position, coolant temp, oil temp and pressure, etc.). Or you could con...

Agreed, the AiM stuff is way better than the 15 years old Stack stuff. That's why my Stack dash is in a box! Anyway, do let us know how the install goes. I found the MXS to be a tight fit with all the...