Dan Millsaps

That is super helpful, I will begin diagnostics and resolution during my hot summer break now and get to know all these parts much better.

Thanks for all the responses. I did talk to a few people as well as Radical (dealer) race team, fix was not possible at the track on Sunday unfortunately. As for comments above about using smart st...

I have never changed fuel filter, dont even know where it is located. I did have full SM engine rebuild done last summer. I dont know what fuel pressure sensor looks like or located. I do know wher...

I was on track this morning during first DE session at Road Atlanta. At full throttle towards end of back straight away at full speed, engine cut off. Got red message across smart steering wheel scr...

I purchase clamps from Belmetric. CV89BAND7 - Oetiker Stepless 7mm Band (16700085) for the large diameter

No, just check large plug (safety wired) on rear drivers side casing. That is overflow hole with magnetic plug.

Yes, very straightforward and easy after the first one. Simply remove teh top bolt from suspension arm to wheel upright (safety wired). Then, the upright will swing out allowing enough room to manue...

See photos. The pneumatic shifter attachment point has failed and barely attached after this weekend's track event (explains the unusual shifting observations). I know this is not right, but how sho...

The tires are directional marked. I talked to Hankook about this exact subject, they said the tires are intended to run in proper noted direction for the 1st heat cycle only. After that, they can be...

Every piece of my internal engine/trans including heads was replaced except the block apparently. A box of all the removed parts also accompanied my rebuild engine when it shipped back.

Does anyone have exact part number for the TPS and a USA source outside of Radical?

On a side note, I carefully watched these parts replacements and procedures closely this time as it was my first chance to see it in action. Wow, that TPS needs a simple micro-adjustment feature inde...

Yes it is possible it was damaged during handling/installation by others, not me. Thus, not pursuing elevating it higher. With that being said, me the consumer is caught paying for more stuff unnece...

Mine cost $271 ea. I guess I can understand a part going bad after service, but straight out of box, crazy that we have to pay for this. Normally I care spare critical parts myself, but at present, ...

As many have seen from my other post on recent TPS and ACT sensor issues after engine rebuild. What a racket. Maybe I was just lucky with my first ~15 months with SR3XX with no problems, but am scar...