Rod Bender

Figured it out! There is indeed no trick, interesting note as well there is a little light on the sensor that triggers when it is the correct distance from a bolt. My issue was of course simple as usu...

@smoothcriminal Not good to see! Do you have any history on the engine, like when it was rebuilt? Who buy? Did it have a seal on it? There does not look to be any detonation that I can see in those p...

So I got a set of these also. But was told by a Radical shop that the safety pins scratch the wheels easier then the bolt setup does. Just watch what’s hanging down and maybe only install once station...

Perhaps it's just me but every time I used the factory nut and bolt setup I'd always drop the nut off while installing or removing them and it would inevitably bounce under the car wasting even more t...

This has been covered on the RSR in the past, but not definitively. Leaving this information here for the next poor fellow who is in this situation -- this is what you might call a Comedy of Errors. ...

@meatman Agreed, no balance weight. You should just be able to bolt it in place as detailed above, this will just hold it in place.

@meatman that is the clamp for the balance weight shaft, should be installed on the front of the engine. Balance weights are not used but the shaft has the oil feed blocked and this clamped installed ...

@benoitm, wow, that is significant damage! 😳 I am glad to hear that Radical Iberia is taking care of you.

Getting along..... Attachment : IMG_20220909_203951_01.jpg Attachment : PXL_20220910_035516897.jpg Attachment : PXL_20220910_041000077.jpg But what is this doo Hickey for? ...

Attachment : PXL_20220910_061006651.jpg

well i fixed this. Ricksmotorsport is a wonderful resource and has howto guides for noobs like me, to diagnose the different components that make up the charging system on a bike engine. i simply fol...

I don't think there is a trick. The owner's manual says it should be no closer than 2mm from the brake disc bolts. I installed one and I may have put it a little closer than that and it works well.

Issue sorted! Reached out to Radical and they advised to check the EPAS ECU 31 pin plug. I found 12V at pin 1-2 as required and the harness was fine. There was no power going from the ECU to the Motor...

The Rapture Registry was just added... Take a look. 🙂

Early Busa's (99-01) didn't have these washers fitted as standard but everything else did. Radical leave them in everything and fit them to engines without them to assist. Having said that you should ...