Thomas Miller

Posted by: @gwt561324 The manual suggests opening the case and draining the fluid that way. Rather than do that and worry about the seal on the case each time, we tend to just remove the lower hose f...

@gwt561324 What is the secret to draining the GDU?

@raider89 These guys....

Garrett...here are the things that I just picked/borrowed/used over the last few months and have been happy with them. For scales I used these and was super happy. For rolloffs we bought these and we...

Posted by: @kitleslie @tommymills Awesome, glad to see your entered. Excited to be running with you guys. Look forward to meeting you.

Posted by: @gwt561324 Inspired by @kitleslie I went to check out Eagles Canyon. Great track with several sweeping corners that make the Radical come alive. Definitely more time on the table but it wa...

Does anybody know where we can get some Radical gear? I would love to have a hat or shirt or similar to show my love for the brand. I can't seem to find anything available. Is this only available at R...

Posted by: @azwcat @jamolah, note that the maintenance interval is referenced to engine run time, not track time. Due to warm up and other factors, your engine run time will be 2-3x your actual on t...

Here is what I bought. 1. Front lift jack... 2. Lift Stands... 3. Not sure on that...I just set mine on some plastic saw horses. 4. No first hand experience, but my driving buddy has that exact r...

Posted by: @graemed Yes, I think Intrax have the ability to adjust shock length, so this is how I set the Penske dampers. This is the Radical procedure. disconnect nick-link, substitute driver weigh...

Posted by: @azwcat @tommymills, thanks, I missed the page on car setup in the manual. Looking it over, I think you got the sequence correct. It is interesting that the front splitter height seems t...

Posted by: @graemed set it as low as you can without bottoming out the chassis. Then use tire temps to set the camber and toe. The recommended setting in the manual is a good place to start with. I ...

@azwcat I am new to this also so take my comments for what they are. The ride height is measure using a bar over the tires and measured to a fixed point on the chassis. This is described in the manual...

Welcome Jim!

I worked all week to get a new setup on the car. I went with the Hankook 'recipe' from the manual and I must say it was a good starting point. There are some things I can tweak to get some improvement...