Welcome Clark. It is a small world. I live in Tennessee but I am also a member of VIR and I know Danyel and his team well.I also have a steep drivew...

I was a little worried that this would be a big job, but it went quite well on my SR3 XX. I left the radiator connected to the side pod, and disconne...

Which bolts are you referring to? I always remove the entire caliper from the chassis uprights and discs to replace the pads. These bolts on my cars...

Several of the Radical dealer techs have told me to replace when the pad thickness is less than 5mm. So if any part of the pad is less than 5mm, I re...

I just removed the entire half of the fiberglass panel under the roll bar that Charley described. Drill through the center of each rivet with a 4mm o...

I have raced my SR3 1500cc in P2 class at an SCCA event. It depends on the event, but often there will be a mix of Formula Atlantic, Formula Mazda/Ma...

“As we reach this milestone it is good to take a moment to look back and see where we’ve come from. Charley’s depth of knowledge is second-to-none, an...

Very clean SR3 Seth. Congratulations and enjoy!

Zoro.com link:

@parsonsj Various places sell these including Amazon. I cannot remember where I purchased mine, but these are all the same as long as the size is ...

In my experience: You don't have to ratchet down crazy tight If you over tighten the strap, it could bend a rod end or upright. I would much rat...